Answers
Aug 27, 2016 - 03:25 AM
Hi. There is no video that I am aware of. I purchased one of these to operate my motorised curtains but after a few days it stops working and I have to depower it for a few minutes before it will work again. I am currently trying to figure out if it's a fault or the way I have wired this unit. I had it wired so the curtain switch was on l1 and l2 and the curtain motor on q1 and q2. As the switch is push to break I'm wondering if this is confusing the device.
Aug 28, 2016 - 12:05 PM
The user manual has very clear wiring diagrams, so I would suggest using those. It is relatively straightforward wiring.
http://www.vesternet.com/downloads/dl...
http://www.vesternet.com/downloads/dl...
Aug 28, 2016 - 02:47 PM
Yes it seems clear but I'm confused with the following sentence 'Electrical installation must be protected by over current protection fuse 4A, Tag lag T, rated breaking capacity 1500V (ESKA 522.7..)'
Do I have to connect fuse or something like that? or is it ok to just wire the cables?
Do I have to connect fuse or something like that? or is it ok to just wire the cables?
Add New Comment