I'm trying to use this switch to control load by both S1 and S2 (connected to separate switch), but it my case switch connected into S2 has no impact on the load. I had no problem with achieving the same effect with Everspring module AN179, but somehow it does not work with Fibaro. Have anyone has achieved such configuration (controlling load by both S1 & S2)?
Z-Wave Fibaro Single Switch 2
I'm trying to use this switch to control load by both S1 and S2 (connected to separate switch), but it my case switch connected into S2 has no impact on the load. I had no problem with achieving the same effect with Everspring module AN179, but somehow it does not work with Fibaro. Have anyone has achieved such configuration (controlling load by both S1 & S2)?
Question ID: 4191964 Status:
Open Mar 06, 2018 - 06:36 AM
1answer
Answers
Mar 08, 2018 - 04:40 PM
Hi Jan,
The S2 input on the Switch 2 can't be used to control the local load in a 2-way circuit.
You'd normally feed the switched live from the switch into S1.
Add New Comment